When using the StaffAlerter or ContactNotifier equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and other personal injury, including the following:

• Please read and understand all instructions.
• Follow all warnings and instructions marked on the product.
• Unplug this product from the wall outlet before cleaning. A slightly damp cloth should be used for cleaning; do not use liquid or aerosol cleaners.
• Do not use this product near water, such as bathtub, washbowl, kitchen sink or laundry tub, a wet basement, or near a swimming pool.
• Do not place this product on an unstable stand or table. The product may fall, causing serious damage to the product.
• Slots and openings in the chassis side, back, top, or bottom are provided for ventilation and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked. This product should never be placed near or over a radiator or other heat source. This product should not be placed in a built-in installation without proper ventilation.
• This product should be operated only from the type of power source indicated on the power supply label. If you are not sure of the type of power supply to your location, consult a certified electrician or local power company.
• Do not allow anything to rest on the power cord. Do not locate this product where the cord could be damaged by people walking on it.
• Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
• Never push objects of any kind into this product through chassis slots or connectors as they may touch dangerous voltage points or short out parts that could result in a risk of fire, electric shock or product failure. Never spill liquid of any kind on the product.
• To reduce the risk of electric shock, do not disassemble this product. Instead, take it to a qualified person when service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risk. Incorrect reassemble can cause electric shock when the appliance is subsequently used.
• Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
  • When the power supply cord or plug is damaged or frayed.
  • If liquid has been spilled into the product.
  • If the product has been exposed to rain or water.
  • If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation
  • If the product has been dropped or the chassis has been damaged.
  • If the product exhibits a distinct change in performance.
• In the event of a gas leak, do not use the StaffAlerter / Contact Notifier near the leak.

Precaution

• Keep the system away from heating appliances and electrical noise generating devices such as florescent lamps, motors and televisions. These noise sources can interfere with the performance of the StaffAlerter and ContactNotifier Systems.
• This system should be kept free of dust, moisture, high temperature (more than 40 degrees) and vibration, and should not be exposed to direct sunlight.
• Never attempt to insert wires, pins, etc. into the system. If the system does not operate properly, the equipment should be repaired by an authorized PM Power Products service center.
• Do not use benzene, paint thinner, or an abrasive powder to clean the Cabinet or Module. Wipe it with a soft cloth only.
• This system should only be installed and serviced by qualified service personnel.